This parameter can only be used in conjunction with routeType=thrilling. Note : This parameter is required for The Combustion Consumption Model. The valid range for the consumption values(expressed in l/100km) is between 0.00.0. Consumption rates for speeds not in the list are found as follows: The list defines points on a consumption curve. Provided as an unordered list of colon-delimited speed & consumption-rate pairs. This parameter is required for Electric consumption model.Ĭonstant Speed Consumption InLiters Per Hundredkm The valid range for the consumption values(expressed in kWh/100km) is between 0.00.0. Similarly, consumption values specified for the two smallest speeds in the list cannot lead to a negative consumption rate for any smaller speed. This ensures that extrapolation does not lead to negative consumption rates. If it only contains a single point, then the consumption rate of that point is used without further processing.Ĭonsumption specified for the largest speed must be greater than or equal to that of the penultimate largest speed. The list must contain between 1 and 25 points (inclusive), and may not contain duplicate points for the same speed. Consumption rates for speeds not in the list are found as follows:īy linear interpolation, if the given speed lies in between two speeds in the listīy linear extrapolation otherwise, assuming a constant (ΔConsumption/ΔSpeed) determined by the nearest two points in the list Provided as an unordered list of speed/consumption-rate pairs. Specifies the speed-dependent component of consumption. GET URI Parameters NameĬonstant Speed Consumption Ink WhPer Hundredkm
0 Comments
Leave a Reply. |